sheet width 3060 mm
plate thickness 6.0 mm
thickness at "Niro-steel" 4.0 mm
distance between columns 3100 mm
down holder 16 Stück
no. of strokes 20 Hub/min
oil volume 160 ltr.
cutting angle 1.6 °
Control ELGO
Number of working hours ~ 1.100 h
total power requirement 11.0 kW
weight 5250 kg
range L-W-H 3800 x 1940 x 1560 mm
** from a maintenance workshop
** with only approx. 1.100 operating hours (!!)

Equipment:
- electro-hydraulic swing beam shears
- ELGO NC control unit
* for electric back stop
* Input of target/actual position value possible
- NC electro-motoric back stop
* travel path of back stop X = 750 mm
* back stop ball screw with no play
* travel speed 100 mm/sec
- electric cutting length limitation
* cutting length limitation to increase the number of strokes/min.
- manual cutting gap adjustment, via eccentric
- tip operation with push buttons on the control panel on the left
- front support plates with ball rollers
- front finger/interference protection
- 1x side stop with T-slot + millimeter scale
- 2x front support arms
- original operating instructions including CE declaration
The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.